Wood Carve
Wood Carve
Check out this page if you are looking for Wood Carve
 |
 BOOK Creating Caricature Heads by Marv Kaisersatt wood carving hobby carve  US $24.95
|
 How to Carve a ZEBRA 1950s PINE WOOD CARVING PATTERN US $4.99
|
 3 x 7 x 575 Spalted Basswood Lumber Wood Carve Turn US $45.00
|
 Bright Creamy Air Dried Buckeye Lumber Wood Carve Turn 1 3 4 x 7 3 4 x 53 US $14.99
|
 3 1 2 x 5 5 8 x 57 1 2 Basswood Lumber Wood Carve Turn Chunk US $39.99
|
 21 pc Ultimate starter Carving wood lot basswood butternut hitty carve craft US $19.95
|
 WOOD CARVING BOOKS WOOD CARVING WILD ANIMALS BEARS TO CARVE WITH DALE POWER US $10.95
|
 Three Pieces Chunky Basswood Lumber Wood Carve Turn Kiln Dried CLEAR US $14.99
|
 Wild Looking Spalted Wormy Ambrosia Basswood Lumber Wood Carve Turn Or US $9.99
|
 4 x 9 3 4 x 17 Basswood Lumber Wood Carve Turn Chunk Kiln Dried Clear US $21.99
|
 Four SASSAFRAS Lumber Wood SPIRIT FACE Carving Blanks Half Logs Ready 2 Carve US $14.99
|
How can i start wood carving?
I really want to get into carving things out of wood, but I have no where to start! I don't want to do anything fancy or big just like a small sculpture or something. Are there any specific tools or anything that I should use or should I just get like a carving knife and some wood from a craft store? Any advice would help! Thanks! 
)
ummm.. no
do NOT go to the craft store unless money is not a issue for you!
go to the hardware store and get a scrap piece of white pine and a hand saw, you want to watch the grain of the wood, cut off a piece of the wood about the size of a dollar bill that has no knot holes, then find a picture of a subject (person, building, animal) that would fit on the biggest face of the wood, trace the picture using tracing paper, then put the paper on the wood and coppy the tracing to the wood, a moderate amount of pressure applied over the paper will transfer the pattern to the surface, then you can start carving. any small sharp knife with a fine point will do, keep your fingers out of the way, and remember a dull blade is dangerous, you are more likly to slip with a dull blade and on the ocashion that you do cut yourself, it takes a lot longer for a cut with a dull blade to heal.
start following the pattern with your knife, to remove the wood you want to cut away, make two cuts, your first at a 45 degree angle, and the second at the same angle reversed, so youve cut a trough. let your imagination guide you till youve decide your project is ready for sanding, then use a fine grit sand paper to finish and smoth out the edges.